I04 Rev; I05 Up; I06 Down; I07 Reset - Zener MSC-3 Instruction Manual

MSC-3 Start Up
While this input is held the motor will run in the forward direction. When the input is removed the motor
will stop running (non-latching). The I03 FWD function disregards the state of the I02 ~STOP input and
the drive will not stop while I03 FWD input is present and the Enable input is wired to +5V. Both I03 FWD
& I04 REV inputs must be wired to +5 to activate bipolar operation.

I04 REV

Available Choices:
• Press  once to begin input selection.
• Use the ▲ / ▼ buttons to select a digital signal source.
• Press  to confirm the choice. ESC to abandon the change.
The I04 REV (non-latching) function disregards the state of the I02 ~STOP input and the drive will not
stop while I04 REV input is held and the Enable input is wired to +5V. Both I03 FWD & I04 REV inputs
must be wired to +5 to activate bipolar operation. D03 REVERSE must be Enabled for the motor to run
backwards.

I05 UP

Available Choices:
• Press  once to begin input selection.
• Use the ▲ / ▼ buttons to select a digital signal source.
• Press  to confirm the choice. ESC to abandon the change.
When this input is active the CONSOLE reference increases. The CONSOLE reference must be the
active reference for this input to have an effect.

I06 DOWN

Available Choices:
• Press  once to begin input selection.
• Use the ▲ / ▼ buttons to select a digital signal source.
• Press  to confirm the choice. ESC to abandon the change.
When this input is active the CONSOLE reference decreases. The CONSOLE reference must be the
active reference for this input to have an effect.

I07 RESET

Available Choices:
• Press  once to begin input selection.
92
I04 REV
> OFF
See the list of the G01 Inpt fxn CFG menu
I05 UP
> OFF
See the list of the G01 Inpt fxn CFG menu
I06 DOWN
> OFF
See the list of the G01 Inpt fxn CFG menu
I07 RESET
> D1(2)
See the list of the G01 Inpt fxn CFG menu
IM00120 IM00120