Zener MSC-3 Instruction Manual page 16

Warnings
Mount the MSC-3 on a vertical, incombustible surface such as metal or masonry. Do not place
combustible or flammable material near the MSC-3. Failure to observe these precautions may create a
fire hazard.
The MSC-3 is manufactured under strict quality control arrangements, however additional and
independent safety equipment must be installed if the application is such that failure of the product may
result in personal injury or property damage.
Ensure that electrical noise generated by the product and any associated equipment does not adversely
affect the proper operation of other equipment or systems, particularly those that have a safety function.
Install emergency stop circuitry that removes power from the MSC-3 and does not depend on any
feature of the product for proper and safe operation. Do not use the braking functions of the product for
safety purposes.
The MSC-3 has features that may be used to cause an automatic restart in certain circumstances. The
overall application (machine etc) must be designed such that automatic restart is not hazardous.
Do not install this equipment in locations where mechanical damage to the enclosure is possible. In
particular, consider vehicles, vandalism and attack by insects or animals. Severe equipment damage
and safety hazards may result.
Receiving
Inspect the MSC-3 for any shipping damage. If any damage is found, report it to the carrier immediately.
Access the inside of the controller and visually check for any damage.
Do not attempt to operate the MSC-3 if any obvious damage exists.
After the initial inspection, the MSC-3 can be repacked and stored in a clean, dry location until it is
required for use.
DO NOT store this equipment in an area where the ambient temperature will fall below -20oC (-4oF)
or rise above 70oC (158oF). DO NOT store this equipment in areas that are subject to condensation
or corrosive atmosphere. Proper storage is necessary to ensure satisfactory controller start up and
performance.
Software
This manual applies to MSC-3 software revision 5.0.1. The software revision is displayed briefly at power
up and may also be viewed in the service menu.
2
IM00120 IM00120