Meter Display - Zener MSC-3 Instruction Manual

Meter Display

The Meter Display shows other
MSC-3 operating values such as
output current, output power, motor
load as well as motor speed. The PID
facet displays the process variable
and set point value. The PID-Meter
facet helps to relate the motor speed,
output power and motor current to the
Process variable. The kWhrs & Hours
Run facet displays the accumulated
kWhrs to the motor and the numbers
of hours the motor has been running
for. Each Meter Display facet is viewed
by pressing the  button.
Note: Each example display is shown
with the EIA/RS-485 communication
indicator. Refer to the previous section
for details.
Menus
Entry to the Menu Display is identified by:
Use the ▲ and ▼ push buttons to display each menu item. Press the  push button to enter a sub
menu or change a parameter. Press ESC to exit a sub menu or abandon a parameter change. The
subsequent sections of this document explain the parameters found within menu system.
(Meter Display facet)
25.0Hz
8.0A
(PID facet)
11.4 kPa
P
V
23.4
S
V
ENTER
(PID-Meter facet)
25.0Hz
8.0A
(kWhrs & Hours Run facet)
A00 DEFAULTS
IM00120 IM00120
MSC-3 Instruction Manual
0.1kW
ENTER
0%*
*
ENTER
11.4kW
750rpm*
ENTER
0 kWhrs
0 hours*
49