Table of Contents
Advertisement
Programming
Menu Navigation
Note: to change any parameters the SS6000 must be
disabled. Remove the link in the Enable input (term.
14) or the external enable circuit.
The Main Menu
Off
0V
Dashboard screen (1 of 8)
0%
Esc
Enter
Setup Menu
1 Display
Setup Menu
2 Motor
Setup Menu
3 Control
Setup Menu
4 Protection
Setup Menu
5 Inputs
Setup Menu
6 Outputs
Setup Menu
7 Resets
Setup Menu
8 Advanced
Setup Menu
9 Commands
Setup Menu
10 Starter Diag
Technical Manual: Smartstart
Refer to Page 16
Refer to Page 17
Refer to Page 17
Refer to Page 18
Refer to Page 21
Refer to Page 22
Refer to Page 23
Refer to Page 23
Refer to Page 25
Refer to Page 25
®
6000
Setup Menu
1 Display
D01 Menu Access:
Sets the desired user access to menu
Selection:
Default:
To save changes
To exit without saving
If the menu access is disabled a user access code
is required to access the menu. The access code
is 1470.
MENU ACCESS
Read Only
LOGIN CODE
> 1470
D02 Default Screen:
The default screen is the dashboard screen that
the Soft Starter will return to - on power up, exit
or time-out from the menu.
Selection:
Default:
To save changes
To exit without saving
D03 Bargraph Var.:
Sets the bargraph variable to monitor & Display.
Selection:
Default:
To save changes
To exit without saving
D04 Bargraph FS.:
Adjust the full scale of the bar graph meter as a
percentage.
Selection:
Default:
To save changes
To exit without saving
Page 16
Disabled; Setup; Read only
Setup
* Press <Enter> for
3 sec
3 seconds.
Overview; Thermal; Electrical; Power;
Volt imbal; Curr imbal; Counters;
meters
Overview
Mtr current; Mtr Torque;
Mtr Thermal; SCR Thermal; Active
Power; Power Factor
Mtr Current
100;120;150;200;300;400;600
300%
IMI0042 rev D
Advertisement
Table of Contents
