Zener MSC-3 Instruction Manual page 43

Application: Machine drive with forward and reverse jog
This setting is for a typical industrial process that requires stop/start with the ability to jog the machine in
both directions. A roll forming machine may be controlled this way. The speed signal could be from the
 and  buttons on the console or a remote potentiometer.
Procedure
STEP 1. Complete the power wiring according to the instructions on pages 9 to 18
STEP 2. Connect your control wiring as shown.
CAUTION
Do not connect the wire to terminal 6 yet.
The terminal configuration should not be changed while the MSC-3 is enabled.
i
The function of terminals
D1...4 are programmable. In
this configuration the following
functions are assigned to the
terminals:
I02 ~ STOP
I00 FWD & LATCH
I09 JOGFWD
I10 JOGREV
Note:
The I11 REMOTE function
is assigned to "ON" so that
the MSC-3 always operates
in the REMOTE mode.
D1
D2
D3
MSC - 3 Control Board
D4
+5V D1
1 2
Stop/
Reset
Forward
Jog Forward
Jog Reverse
IM00120 IM00120
MSC-3 Instruction Manual
D2 D3 D4 EN COM SCN
3 4 5 6 8
7
29