C00 Performance Menu; C01 Minimum Hz; C010 Min Hz; B04 Motor Rpm - Zener MSC-3 Instruction Manual

MSC-3 Start Up

B04 MOTOR RPM

Range: 500...60 x B03 MOTOR Hz
• Press  to edit the value.
• Press ▲/ ▼ to make changes to the value.
• Press  to accept the new value OR
• Press ESC to abandon the value change.
The value entered is taken from the motor nameplate and is an important parameter of the motor control
algorithm. Note the maximum value is x60 the current B03 MOTOR Hz value.

C00 PERFORMANCE Menu

Parameters found within this menu allow motor performance characteristics to be set. Parameters
include the minimum and maximum speed of the motor, motor speed ramp times, motor slip
compensation and acoustic performance.

C01 MINIMUM Hz

Parameters found in this menu set the performance of features related to minimum output Hz including
the minimum speed idle function.

C010 MIN Hz

Range: 0...C02 MAX Hz - 5Hz
• Press  to edit the value.
• Press ▲/ ▼ to make changes to the value.
• Press  to accept the new value OR
• Press ESC to abandon the value change.
This sets the minimum frequency that the MSC-3 will run at when given a run signal. The value is entered
in Hz. There must be a difference of at least 5Hz between the C010 MIN Hz and the C02 MAX Hz
setting. For example, if C020 MAX Hz is set to 45Hz, then the largest allowed value for C010 MIN Hz is
40Hz.
It is possible to use the full span of an analogue input to adjust the speed reference from C010 MIN Hz
through to C02 MAX Hz. Refer to the G02 AN IN Config menu for details.
72
B04 MOTOR RPM
1465 RPM
C010 MIN Hz
0 Hz
IM00120 IM00120