H07 Pv Choice; H08 Pid Units; H09 Pid Scale - Zener MSC-3 Instruction Manual

H07 PV choice

Available Choices:
• Press  once to begin a selection.
• Use the ▲ / ▼ buttons to select a reference.
• Press  to confirm the choice.
The H07 PV choice is the analogue input on which the process variable is measured. Refer to the menus
of the selected analogue input for spanning, offset and limit alarm configurations.

H08 PID Units

Available characters:
• Press  and the character to enter begins to flash
• Press ▲ & ▼ to move through the list of available characters
• Press  to select the displayed character; the cursor moves to the next character OR the edit
completes
• Press the ESC button to abandon changes
The H08 PID Units are displayed on the PID run display and a total of 8 characters may be displayed as
units.

H09 PID Scale

Available Range:
• Press  to edit the value.
• Press ▲/ ▼ to make changes to the value.
• Press  to accept the new value OR
• Press ESC to abandon the value change.
The H09 PID Scale is used to scale the SV and PV values for the PID run display only and does not
affect the PID control loop.
H07 PV choice
>AN IN
> AN IN
> LHS AN IN (if left-hand Extended Features card fitted)
> RHS AN IN (if right-hand Extended Features card fitted)
H08 PID Units
> %
0...9,
A...Z, a...Z,
punctuation characters,
+, -, *, /, |, #, $, ^, &, !, ~,
{}, [], ()
H09 PID Scale
> 100.0
1.0...1000.0
IM00120 IM00120
MSC-3 Instruction Manual
115