Nip Roller Asy Replacement - Fujitsu DL7600 Maintenance Manual

(49) NIP Roller ASY replacement

[For the front side]
Removal
1. Remove the upper cover.
2. Remove the printer mechanism assembly.
3. Unhook one sides of 4 nip springs and remove 4 spring holders.
4. Remove the E ring of both side and Nip gear on the left side.
Spring holder
（Front side）
5. Remove the SP FAN UNIT and plate.
6. Remove the flanges, slide cam, OC cam and bearings..
7. Lift and slide the Nip roller to the right. And remove it from its left end.
Bearing
Installation
1. Assembly by reveres order.
（Lubrication is necessary refer to lubrication table）
NIPspring
（Front side）
NIP gear
（Front side）
Figure 4.74 Nip Roller ASY replacement
OC cam
Slide cam
Figure 4.75 Nip Roller ASY replacement
Flange
E ring
E ring
104
NIP Roller ASY
（Front side）
Plate
SP FAN UNIT
Screws