(13) Print Mechanism Unit replacement
Removal
* Do this work on a no slippery level bench so that the mechanism can be tilted stably during replacement.
On a slippery surface like paper, the printer may slide when the
mechanism is tilted. It deteriorates the work efficiency.
1. Remove the upper cover.
2. Access the mechanism assembly from the back of the printer.
3. As shown in the following figure, a hand is hung on the side frame part of mecha unit.
4. Slowly hold up the mechanism unit on the upper side.
Note; Too high position cause unplug the connector. So be carefully.
The finger is hung on the portion of the side frame to L Bend.
Figure 4.28 Print Mechanism Unit removal
62