Fujitsu DL7600 Maintenance Manual page 113

7. Adjust the head gap to value A, by turning the SS gear.
Stopper of SS gear
SS gear
Stopper stud
Figure 4.91 Rotate SS gear
A=0.27mm±0.01mm
8. Move the card guide up and down so that APTC SW should be switched into conducting state at the head gap is
value A. (The value A should be checked during the SS gear is rotating in the direction of clockwise.)
9. Slope of card guide should be as follows.
1P 55kg
t=0.08
APTC SW Platen
Gap confirmation area
About 15 mm
1P 55kg
t=0.08*8
Figure 4.92 Adjustment and check inclination of card guide
113