Fujitsu DL7600 Maintenance Manual page 107

10. Remove 4 screws fixing lower guide at front and rear side.
11. Shift the lower guide a little upward.
Screw securing the lower guide
12. Remove the lower plate.
Disconnect cables backside of printer mechanism unit, remove 6 screws of lower plate.
13. Slide the DV rollerr assembly direction of arrow, then remove it.
14. Replace assembled parts on the DV roller.
Installation
1. Assembly by reverse order the removal.
Note Lubrication is necessary to right and left shaft of Platen roll.
(Refer to lubrication tables)
NOTE）after installation, the following adjustment are required.
(1)LF belt tension Note Lubrication is necessary to right and left shaft of Platen roll.
(Refer to lubrication tables)
Figure 4.80 DV Roller ASY replacement
Screw securing the lower
Figure 4.81 DV Roller ASY replacement
Lower guide
107
DV roller ASY
(Front side)