Fujitsu DL7600 Maintenance Manual page 136

4.10.3 Power-on Features for DL7600
There are several special tests and setup modes built into the DL7600 printers. Holding down certain control
panel buttons, while turning on the printer, activates these special printer modes.
After the printer beeps, the buttons are released.
Please do not open these features to end-users, just use for CE check.
The chart below shows the relationship between the control panel buttons and the various power on modes.
[LED type]
▼ ▲
●
●
●
●
●
● ●
● ●
●
Denotes a button that is pressed down to activate a test mode.
Note 1: Print a listing of the printer setup before resetting the EEPROM. Then reprogram the printer to the
required
settings. Reset items are as follows:
(1)Settings of Setup
(2)Mechanical settings
(3)Error Log
a) All EEPROM Reset: ONLINE + TEAR OFF + LOAD: Reset (1), (2), (3)
b) EEPROM All Settings Reset : LF/FF + ONLINE + LOAD: Reset (1) and (2)
c) EEPROM Reset : TEAR OFF + LOAD: Reset (1) only
Special Power-on Features
Button Name
● ●
●
●
● ●
●
● ●
● ●
●
Offline Setup Mode
●
Online Setup Mode
Self Test Print Mode
● ●
EEPROM DATA Print Mode
●
HEX Dump Mode
●
Vertical Alignment Mode
TOF adjustment Mode
PE adjustment Mode
●
Left start position adjustment mode.
●
Skew detect adjustment mode.
Factory adjustment mode
Sensor adjustment Mode
● ● ●
All EEPROM Reset (Note 1, a)
● ●
EEPROM All Settings Reset (Note 1, b)
● ●
Reset set up value. (Note 1, c)
●
Error Log Clear
● ●
Flash ROM Update Mode
No Print Mode
List Setup Parameters
Demonstration Print Mode
136
Function Description