5.3.1.1 Outline of Printed Circuit Boards
Main board (HGC07**)
This printed circuit board consists of three basic blocks: the main control circuit, interface circuit, and drive circuit blocks.
The main board has the following ten connectors:
No.
Name
1
Centronics connector
2
Control panel connector
3
Power supply connector
4
Carriage board connector
5
Head cable connector
6
Space motor cable
7
Line feed motor cable
8
Tractor motor cable
9
Sheet feeder cable
10
Sensor board connection cable
11
USB connector
12
RS232C connector
13
Ribbon feed motor cable
14
Power supply FAN connector
15
Space motor driver FAN connector
16
Space motor FAN connector
17
Head FAN connector
18
Inter rock connector
Power supply board (KA0071/KA0076)
This printed circuit board supplies logic power (+5 V) and driving power (+40V) to the main board.
The driving power can be turned on and off by the control signal (PWSTOP) from the main board.
This printed circuit board has an AC inlet for AC cable connection, the AC switch, and main board connection harness.
Control panel board (GAO99BA/LCD02BA)
This printed circuit board has printer status display LCD/LEDs and mode setting switches.
It also has the main board connector (CNOP).
Abbreviation
Connection destination
IFCEN
Host computer
CNOP
Control panel board
CNPW
Power supply board
CNHD3
Multi-sensor for detection of left and right ends
FCNHD1
Print head
FCNHD2
CNSP
Space motor
CNMLF
Line feed motor
CNTLF
Tractor motor
Front:CNFCSF
Sheet feeder connector board
Rear:CNRCSF
CNSEN
Mechanism board (sensor board)
CNUSB
Host computer
CNFRS
Host computer
CNRF
Ribbon feed motor
CNFAN1
Power supply FAN
CNFAN2
Space motor driver FAN
CNFAN3
Space motor FAN
CNFAN4
HEAD FAN
INLK
Inter rock switch
152