Fujitsu DL7600 Maintenance Manual page 64

7. Lift up the rear of the mechanism unit and then place the tilt
8. Lift up the rear of the mechanism unit and then place the tilt bar hole of the rubber foot(5)and hole of
the lower cover to support mechanism unit.
9. Unplug cables from mechanism unit.
(SP motor cable, LF motor cable, TR motor cable, RF motor cable, Carrier cable (3 flat cables), RCSF cable,
Relay cable, INLK sw cable, CO sw cable, FAN2 cable, FAN3 cable, FAN4 cable. Total 14 cables)
10. Remove the screws securing the FG cable
11. Lift the mechanism unit higher and remove it.
INLK sw cable
Figure 4.31 Print Mechanism Unit replacement
CO sw cable
FAN3 cable
Relay cable
SP motor cables
Figure 4.32 Print Mechanism Unit replacement
LF Motor cable
Carrier cable
(3 FFC Cables)
64
TR Motor cable
FAN2 cable
FAN4 cable
RF Motor cable
R-CSF