Cut Sheet Feeder Replacement - Fujitsu DL7600 Maintenance Manual

(2) Cut Sheet Feeder replacement

Front cut sheet feeder
Removal
1. Turn off the printer power.
2. Disconnect the cut sheet feeder cable.
3. Raise the paper table, then hold both ends of the cut sheet feeder and pull it off.
Installation
1. Install the cut sheet feeder by reversing the removal procedure.
2. Turn off the printer power.
3. Raise the paper table, then engage the U-grooves on both ends of the cut sheet feeder with the mounting pins on
the printer and lower the cut sheet feeder carefully.
(Push in the cut sheet feeder while aligning label A on the feeder with label A on the right side of the printer.)
4. Connect the cut sheet feeder cable connector to the connector on the front right of the printer.
5. Insert the connector with the arrow side facing upward.
Note. When attaching the cut sheet feeder to the front of the printer, removing the tractor and replacing
soundproof cover with large or small paper table are necessary.
Mounting pin 1
Mounting pin 2
Figure 4.8 Front Cut Sheet Feeder replacement
Paper table
Mounting pin
47
Connector