Cleaning The Platen Roller - Fujitsu FP-510II User Manual

8-2. Cleaning the Platen Roller

The cleaning procedure is as follows.
(1) With paper inserted in the printer, turn off the printer power switch
once, and turn on the switch again while holding down the FEED
switch on the control panel. Then, the data shown below is printed.
Caution: If you have passed the item that you want to select,
(2) Press the FEED switch briefly (one second or less) three times to move
to "PLATEN ROLLER CLEANING."
repeatedly press the FEED switch briefly until you return to
the first item.
TEST PRINT
END
SAMPLE PRINT
CUTTER CLEANING
PLATEN ROLLER CLEAING
SET UP
HEX DUMP
TEST PRINT
SELECTION ITEM
ITEM SELECTION :FEED switch pushed short.
ITEM DECSION :FEED switch pushed short.
SPECIAL MODE
PLATEN ROLLER CLEANING
↑
SET UP
↑
HEX DUMP
↑
TEST PRINT
END
SAMPLE PRINT
CUTTER CLEANING
PLATEN ROLLER CLEAING
SET UP
HEX DUMP
TEST PRINT
SELECTION ITEM
ITEM SELECTION :FEED switch pushed short.
ITEM DECSION :FEED switch pushed short.
SPECIAL MODE
49 / 125