Card Guide Position Adjustment - Fujitsu DL7600 Maintenance Manual

(2) Card guide position adjustment

Note:
For improve the precision using the head gap adjustment jig is better.
If you don't have the head gap adjustment jig refer to the another procedure which comes out behind
[Using the head gap adjustment jig]
This adjustment should be done after print head gap adjustment is finished.
1. Attach the head gap adjustment jig on the carriage.
2. Open the upper guide F open.
3. Place the carriage to the ribbon replace position.
4. Loosen the card guide mounting screws slightly (to an extent where the card guide doesn't drop towards
the platen).
Direction of moving
card guide
5. Enter adjustment mode
Turn the power on while pushing " "SW and " "SW of operation panel. Then printer enters the adjustment
mode. Any motors don't move in this mode.
6. Place one sheet of 1p-55kg paper between the card guide and platen at the APTC switch side.
1P 55Kg paper
t=0.08
Platen
Figure 4.89 Attach the head gap adjustment jig
Screw
Platen
Figure 4.90 Insert paper for adjustment
Head gap adjustment jig
Card guide
Screw
APTC SW
112
Upper guide F