Replacing The Roller Set - Fujitsu SP-1120 Operator's Manual

Chapter 6 Replacing the Consumables

6.2 Replacing the Roller Set

The roller set consists of a brake roller and a pick roller.
Replace each roller in the following procedure.
1
Remove all documents from the ADF paper chute
(feeder).
2
Open the ADF.
For details, refer to "1.4 Opening/Closing the ADF" (page
Be careful not to have your fingers caught
when the ADF closes.
CAUTION
3
Remove the brake roller.
1 Press the cover bushing of the brake roller to open the cover in the
direction of the arrow.
Bushing
2 Pull out the left side of the brake roller shaft, and then pull out the
right side of the shaft from the hole.
17).
4
Remove the brake roller from its shaft.
Cover
Brake roller shaft
Brake roller
2
1
Brake roller
Brake roller shaft
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
59