Mobile Phone Read Mode; Image Snap And Ship; Hands Free Time-Out - Honeywell Xenon 1900 User Manual

Mobile Phone Read Mode

When this mode is selected, your scanner is optimized to read bar codes from
mobile phone or other LED displays. However, the speed of scanning printed
bar codes may be slightly lower when this mode is enabled. You can enable
Mobile Phone Reading for either a hand held device, or for a hands-free (pre-
sentation) application.
Hand Held Scanning - Mobile
Phone
Note: To turn off Mobil Phone Read Mode, scan a Manual or Serial Trigger
Mode bar code (see page 4-6).

Image Snap and Ship

Image Snap and Ship tells the scanner to take a picture (rather than read a bar
code) when the trigger is pressed. Once the picture is snapped, it is shipped to
the host system as a jpeg file by default. To revert to bar code reading, you
must change to a different trigger mode (see
beginning on page 4-6).
Note: You must use an RS232 interface to use this code. Otherwise, menu
codes will not work until you send a serial command for
Trigger Modes

Hands Free Time-Out

The Scan Stand and Presentation Modes are referred to as "hands free"
modes. If the scanner's trigger is pulled when using a hands free mode, the
scanner changes to manual trigger mode. You can set the time the scanner
should remain in manual trigger mode by setting the Hands Free Time-Out.
Once the time-out value is reached, (if there have been no further trigger pulls)
the scanner reverts to the original hands free mode.
Image Snap and Ship
(see page 11-18).
Streaming Presentation -
Mobile Phone
Manual/Serial Trigger Modes
Manual/Serial
4 - 11