Table of Contents
Advertisement
®
CodeGate
When CodeGate is On, the trigger is used to allow decoded data to be transmitted
to the host system. The scanner remains on, scanning and decoding barcodes, but
the barcode data is not transmitted until the trigger is pressed. When CodeGate is
Off, barcode data is transmitted when it is decoded. Default = CodeGate Off Out-of-
Stand.
Mobile Phone Read Mode
When this mode is selected, your scanner is optimized to read barcodes from
mobile phone or other LED displays. However, the speed of scanning printed bar-
codes may be slightly lower when this mode is enabled
Note: To turn off Mobile Phone Read Mode, scan the
Hands Free Time-Out
The Scan Stand and Presentation Modes are referred to as "hands free" modes. If
the scanner's trigger is pressed when using a hands free mode, the scanner
changes to manual trigger mode. You can set the time the scanner should remain
in manual trigger mode by setting the Hands Free Time-Out. Once the time-out
value is reached, (if there have been no further trigger presses) the scanner reverts
to the original hands free mode.
Scan the Hands Free Time-Out barcode, then scan the time-out duration (from 0-
300,000 milliseconds) from the
Voyager XP User Guide
* CodeGate Off
Out-of-Stand
Hand Held Scanning - Mobile
Phone
Manual Trigger Mode
Programming
Chart, and Save. Default = 5,000 ms.
Hands Free Time-Out
CodeGate On
Out-of-Stand
barcode.
83
Advertisement
Table of Contents
