Streaming Presentation™ Mode; Streaming Presentation In-Stand Programming; Mobile Phone Read Mode; Hands Free Time-Out - Honeywell Xenon 1900 User Manual

Streaming Presentation ™ Mode
When in Streaming Presentation mode, the scanner's aimer goes out after a short time, but the scan illumination remains on all
the time to continuously search for bar codes. Two modes are available, Normal and Enhanced. Normal mode offers good
scan speed and the longest working ranges (depth of field). Enhanced mode will give you the highest possible scan speed but
slightly less range than Normal mode. Enhanced mode is best used when you require a very fast scan speed and don't require
a long working range.
Streaming Presentation Mode
- Normal
When using Preferred Symbology
Streaming Presentation Mode.
Note: If you are using a cordless charge base, it must have an external power supply plugged into the aux port for Streaming
Presentation to work properly.

Streaming Presentation In-Stand Programming

This option is available when using
Mode for in-stand scanning, and a Manual Trigger mode for out-of-stand scanning. To do this, you must first scan the pre-
ferred Streaming Presentation mode (Normal, Enhanced, or Mobile Phone), then scan the Manual Trigger mode (Normal,
Enhanced, or Mobile Phone) you want to use.

Mobile Phone Read Mode

When this mode is selected, your scanner is optimized to read bar codes from mobile phone or other LED displays. However,
the speed of scanning printed bar codes may be slightly lower when this mode is enabled. You can enable Mobile Phone Read-
ing for either a hand held device, or for a hands-free (presentation) application.
Hand Held Scanning - Mobile
Phone
Note: To turn off Mobil Phone Read Mode, scan a Manual or Serial Trigger Mode bar code (see page 4-6).

Hands Free Time-Out

The Scan Stand and Presentation Modes are referred to as "hands free" modes. If the scanner's trigger is pulled when using a
hands free mode, the scanner changes to manual trigger mode. You can set the time the scanner should remain in manual trig-
ger mode by setting the Hands Free Time-Out. Once the time-out value is reached, (if there have been no further trigger pulls)
the scanner reverts to the original hands free mode.
(page 4-18), a lower priority symbol must be centered on the aiming pattern to be read in
In-Stand Sensor Mode, page 4-10. You may program a specific Streaming Presentation
Streaming Presentation Mode
- Enhanced
Streaming Presentation -
Mobile Phone
4 - 11