Siemens SINAMICS V10 Operating Instructions Manual page 80

Parameter list
Par. No. Name
P0013[16] User defined parameter
Defines a limited set of parameters to which the end user will have access right.
Index:.
P0013[0]
P0013[1]
...
P0013[15]
Dependency:
To prevent changes to user-defined parameter, set P0011 ("lock") to a different value than P0012 ("key").
When locked and the user-defined parameter is activated, the only way to exit the user-defined parameter
(and view other parameters) is to set P0012 ("key") to the value in P0011 ("lock")
Note:
● Alternatively, set P0970 = 48 (factory reset) to perform a factory reset of all parameters and selected
connection macro or set P0970 = 49 (factory reset) to perform a factory reset of all parameters (except
parameters for quick motor data settings) and selected connection macro.
● The default values of P0011 ("lock") and P0012 ("key") are the same
r0018[2] Inverter version display
Displays firmware version number of the inverter or the operator panel
r0018[0]:
r0018[1]:
r0024 Actual Inverter output frequency
Displays actual output frequency. Slip compensation, resonance damping and frequency limitation are
included.
r0025 Actual output voltage
Displays [rms] voltage applied to motor.
r0026 Actual DC-link voltage
Displays DC-link voltage.
r0027 Actual output current
Displays [rms] value of motor current [A].
r0037 Inverter temperature [°C]
Displays internal inverter heatsink temperature.
80
1st user parameter
2nd user parameter
16th user parameter
Inverter firmware version
Firmware version of the operator panel
Range
0 - 65535
--
--
--
--
--
--
Operating Instructions, 08/2011, A5E03453178 (this is not an order number)
Default Unit
0 --
-- --
-- Hz
-- V
-- V
-- A
-- °C
SINAMICS V10