Mounting Dimensions For Door-Mounted Operator Panel; Torques For Fixing The Operator Panel To Cabinet Door - Siemens SINAMICS V10 Operating Instructions Manual

Mounting the operator panel to cabinet door
The inverter has a removable operator panel. If necessary, you can remove the operator panel
from the inverter and mount it to the cabinet door. (See topic "Mounting the operator panel to
cabinet door (Page 31)" for details.)
5.1.4 Mounting the operator panel to cabinet door

Mounting dimensions for door-mounted operator panel

You can detach the operator from inverter body unit and mount it to the cabinet door. This
provides you with the possibility of remote operator panel operation.
30
Figure 5-10 Mounting dimensions (outline dimensions + drill patterns + cut-out dimensions)
Table 5-4
Holes to be drilled
in cabinet door
4
NOTICE
If the screw is damaged during mounting, you can select similar M3 preassembled screws
and assemblies instead. But, make sure the screw length is between 12 mm and 18 mm.
SINAMICS V10
Operating Instructions, 08/2011, A5E03453178 (this is not an order number)
91

Torques for fixing the operator panel to cabinet door

Fixing method
4 x M3 preassembled screw and washer assemblies
(screw length: 12 mm)
5.1 Mechanical installation
66.9
36.6
35
Tightening torque
(Nm)
0.8
Installation
31