Connection Macros Available For Setting In This Mode; Connection Macro Setting In "Connection Macro Selection" Mode - Siemens SINAMICS V10 Operating Instructions Manual

Commissioning
6.6 Overview of various operation modes
NOTICE
The connection macro to be displayed by default depends on the actual wiring.
Make sure that your wiring corresponds with the connection macro selected.
For details, please see Typical connection modes (Page 39)

Connection macros available for setting in this mode

C01 to C11

Connection macro setting in "Connection macro selection" mode

Example: C07
Turn
OK
Figure 6-21 Connection macro setting example
NOTICE
If the inverter is confirming the selection of a connection macro, time consumption is about
50 seconds; if it is confirming the selection of an application macro, the time consumption is
about 20 seconds.
Button/keys inactive in this mode
The STOP, RUN and LOC/REM keys are inactive in this mode.
68
Press
. . .
OK
Automatically
Inverter is confirming
the selection
Operating Instructions, 08/2011, A5E03453178 (this is not an order number)
SINAMICS V10