Installing The Camera - Fantasea Line FA6500 Instruction Manual

INSTALLING THE CAMERA

Since the FA6500 Housing is specifically designed for the Sony a6500 and a6300 mirrorless digital cameras,
installing the camera in the housing is quite simple.
1. If possible, it is recommended to install the
camera inside the housing after the lens
port has been mounted on the housing. If
using exceptionally large lenses which
cannot be installed on the camera prior to
inserting it into the housing since the lens
is too large be inserted through the
housing lens port hole, the lens port
should be mounted on the housing only
after the camera and lens have been
inserted. In such cases, please follow the
instructions provided in step 18 below for
camera installation.
2. Place the housing on a protected surface.
3. Open the housing (see section "Opening the
Housing").
4. Prepare the camera following the instructions
provided in the section "Preparing the Camera".
5. Turn the camera tray port lock rightwards, to the
"UNLOCK" position (image #42).
6. Remove the camera tray from its port by gently
sliding it out.
7. Prior to mounting the camera on the tray, the camera
LCD screen should be tilted in order to allow proper
attachment to the tray. Pull out the bottom of the
LCD screen all the way out (image #43). After camera
installation, the LCD screen should be realigned for a clear view.
Image #42
Image #43
FA6500 Housing Instruction Manual 20170315
31