Fantasea Line FA6500 Instruction Manual page 33

e. Pull the housing Mode Dial up and away from the
housing to allow for smooth installation of the
camera (image #46).
11. Install the tray with camera into the camera tray port by
holding the tray parallel to the housing, aligning the rods
of the tray with those featured on the tray port and
sliding the tray all the way in (image #47).
12. Take special care not to touch or damage the moisture
detector device when installing the camera. The Device
is located inside the housing on the inner (right)
side of the housing interior to the latch dial.
13. Turn the camera tray port lock leftwards, to the
"LOCK" position (image #48). Make sure that the
tray was properly installed and locked by gently
trying to pull it out.
14. Realign the camera LCD screen by slightly
pushing its bottom inwards and pulling its top
outwards until it reaches a complete vertical
angle (image #49).
15. If making use of any electronic triggers, such as a
LED Flash Trigger or an electronic strobe
bulkhead, attach the accessory to the camera
hot-shoe connection.
16. If inserting a silica gel pack inside the housing in
order to prevent moisture, it is best to insert it
on the left side of the camera and to attach it
with tape to the housing wall, where it doesn't
interfere with proper housing operation. It is
important to make sure that the silica gel pack
doesn't stick out, or else it might interfere with
the watertight seal of the housing.
17. Close the housing (see section "Closing the
Housing").
18. When using an exceptionally large lens, you
might find that the lens cannot be installed on
the camera prior to inserting it into the housing,
as the lens is too large to be fully inserted inside
Image #46
Image #47
Image #48
Realign camera LCD screen
Image #49
FA6500 Housing Instruction Manual 20170315
33