Fantasea Line FA6500 Instruction Manual page 23

b. Using a screwdriver or a similar tool,
gently remove the e-clip featured at the
end of the lever (image #23). Make sure
you're removing the e-clip that is
positioned beneath the lever rather than
above it, as removing the e-clip above the
lever will damage the watertight seal of
the control. Also, make sure not to cause
any damage to the housing when using
sharp tools.
c. Gently remove the black lever by pulling it out and away from the control shaft using your
fingers (image #24). You might find it easier to do so when depressing the control from out
of the housing.
d. Store the e-clip and black lever removed for possible future use.
e. Identify a similar replacement component in the conversion kit (image #25).
Image #24
f. Install the new (replacement) lever by inserting
the control shaft into the dedicated hole in the
replacement lever (image #26). Make sure the
lever is pointed upwards when installing it on the
shaft.
g. Reinstall an e-clip on the shaft using a set of
pliers. Be careful not to lose the e-clip during the
process. First position the e-clip around the
dedicated engraving on the shaft, then push the
e-clip against the shaft until it snaps into place
and clicks. You might find it easier to do so when
Image #23
Image #25
Image #26
FA6500 Housing Instruction Manual 20170315
23