Fantasea Line FA6500 Instruction Manual page 36

3. If an accessory is connected to the camera
hot-shoe, disconnect it to allow for safe
camera removal.
4. Turn the camera tray port lock rightwards,
to the "UNLOCK" position (image #53).
5. Remove the camera tray from its port by
gently sliding it out.
6. Loosen the screw that secures the camera
to the tray.
7. Remove the camera from the tray.
8. Reinstall the tray inside the housing to
avoid losing it.
19. When using an exceptionally large lens
which cannot be removed from the housing
with the camera, as it's too large to pass
through the housing lens port hole, the lens
should be dismounted prior to removing
the camera from the housing. Follow the
steps below:
a. After use, thoroughly rinse the
housing fresh water as described in
step 1 above.
b. Remove the lens port from the
housing (see section "Installing and
Removing Lens Ports").
c. Detach the lens from the camera.
With one hand, push the "Lens Release Control". With the other, grab the lens and turn it
counterclockwise until it cannot be turned any farther (image #54). Once the lens has
been turned, it can be removed from the camera by pulling it away from the camera
body.
d. Remove the camera from the housing by following steps 2-8 above.
Image #53
Image #54
FA6500 Housing Instruction Manual 20170315
36