Installing The Camera - Fantasea Line FG7X III R Instruction Manual

6. The white O-ring featured on the back side of
the front door should be visually inspected the front door should be visually inspected
prior to each dive. If there is any debris prior to each dive. If there is any debris
present, gently wipe the area with a soft present, gently wipe the area with a soft
microfiber cloth in order to cleanse it. microfiber cloth in order to cleanse it.
7. The white O-ring featured on the back side of ring featured on the back side of
the front door shouldn't be removed unless t door shouldn't be removed unless
it's damaged.
8. If the white O-ring is removed and replaced,
note that it is not symmetrical and should be note that it is not symmetrical and should be
inserted with its rounded edge
(into its seat) and its pointed edge
outward (image #9). Improper installation of (image #9). Improper installation of
the white O-ring may affect housing ring may affect housing
functionality and watertight seal. functionality and watertight seal.

INSTALLING THE CAMERA

Since the FG7X III R Housing is specifically designed for the
the camera in the housing is quite simple.
1. Make sure the camera is turned off
2. Hold the camera parallel to the housing and then gently install it inside (image # Hold the camera parallel to the housing and then gently install it inside (image # Hold the camera parallel to the housing and then gently install it inside (image #10). Avoid
inserting one side of the camera prior to the other, as this will make the installation difficult and inserting one side of the camera prior to the other, as this will make the installation difficult and inserting one side of the camera prior to the other, as this will make the installation difficult and
might cause damage to the camera or housing. might cause damage to the camera or housing.
3. Take special care not to touch or damage the ake special care not to touch or damage the Vacuum System signal board when installing the
camera. The board is located inside the housing on the inne
opposite the latch dial (image # atch dial (image #11).
featured on the back side of
ring is removed and replaced,
rounded edge facing inward
pointed edge facing
specifically designed for the Canon G7 X Mark III digital camera
is quite simple.
a is turned off.
is located inside the housing on the inner right side of the housing r right side of the housing,
FG7X III R Housing Instruction Manual
16
Image #9
digital camera, installing
when installing the
Instruction Manual 20200220