Mounting And Removing Lens Ports - Fantasea Line FA6500 Instruction Manual

MOUNTING AND REMOVING LENS PORTS

The housing features an FML interchangeable lens port system, which allows using a wide range of
lenses underwater. The housing is compatible with any FML lens port, as well as other lens ports
available in the market. For compatibility information and lens ports available, please visit the Fantasea
website – www.fantasea.com
1. Mounting a lens port on the housing:
a. If possible, it is recommended to mount the lens port on the housing prior to
installing the camera inside. If using exceptionally large lenses which cannot be
installed on the camera prior to inserting it into the housing, the camera and lens can
be installed inside the housing prior to mounting the lens port. Please refer to section
"Installing the Camera" - step 18.
b. For smooth installation and
removal of the lens port, it is
recommended to apply a slight
amount of silicone grease over
the lens port O-ring prior to
installing it on the housing.
c. Place the housing on a
protected surface.
d. Turn the lens port lock
rightwards, so it's seated at the
"UNLOCK" position (image
#32).
e. Remove the body cap from the
housing lens port hole. Store
for future use.
f. Hold the lens port against the
housing port hole and align the
white line marking on the lens
port with the white line
marking on the housing (image
#33).
g. Carefully push the lens port
against the housing until it's fully inserted inside the port hole. Examine the lens port
from all directions to make sure it was evenly inserted.
Image #32
Image #33
FA6500 Housing Instruction Manual 20170315
26