Fantasea Line FA6500 Instruction Manual page 22

Image #19
c. Gently remove the black plastic component by pulling it down, out and away from the
control shaft using your fingers. You might find it easier to do so when depressing the shutter
release control from out of the housing, thereby clearing more space for the black plastic
component to be removed.
d. Store the e-clip and black plastic component removed for possible future use.
e. Identify a similar (but not identical) replacement component
in the conversion kit (image #21).
f. Install the new (replacement) component by inserting the
control shaft into the dedicated hole in the replacement
component.
g. Reinstall an e-clip on the shaft, right below the replacement
component, using a set of pliers. Be careful not to lose the e-
clip during the process. First position the e-clip around the
dedicated engraving on the shaft, then push the e-clip against the shaft until it snaps into
place and clicks. You might find it easier to do so when depressing the control from out of
the housing.
h. Test the control by gently trying to pull it out in order to make sure it has been properly
installed.
5. Movie Recording –
a. Open the housing and identify the interior
component of the Movie Recording control
– a black lever featuring a black rubber tip
at its end, secured to the control shaft with
an e-clip (image #22).
Image #20
Image #22
FA6500 Housing Instruction Manual 20170315
22
Image #21