Installing The Camera - Fantasea Line FRX100 III Housing Instruction Manual

INSTALLING THE CAMERA

Since the FRX100 III Housing is specifically designed for the Sony RX100 III digital camera, installing the
camera in the housing is quite simple.
1. Make sure the camera is turned off.
2. Hold the camera parallel to the housing and then gently install it inside (image #9). Avoid
inserting one side of the camera prior to the other, as this will make the installation difficult and
might cause damage to the camera or housing.
3. Take special care not to touch or damage the moisture detector device when installing the
camera. The Device is located inside the housing on the inner (right) side of the housing
interior to the latch dial (image #10).
MOISTURE DETECTOR
FRX100 III Housing Instruction Manual 20141005
16
Image #9
Image #10