Installing The Camera - Fantasea Line FRX100 IV Instruction Manual

7. Finally, re-install the black rubber disc at the end of the control by pushing it against the shaft
until it is fully and securely seated. Do so by mounting the 2 holes on the disc center onto the 2
protruding points at the end of the black plastic 2-pointed seat.
8. Once complete, install the camera inside the housing and test to control. If properly installed,
the control should work smoothly when turned or pushed against the camera button.
9. The C-shaped washer should remain in this position as long as the housing is used to
accommodate the RX100 III camera. In case of using the housing to accommodate the RX100 IV
camera, the C-shaped washer should be removed.
Important Notice: This procedure should only be followed if using the housing to accommodate the
RX100 III camera. Installing the C-shaped washer when using the housing with the RX100 IV camera
will interfere with housing functionality and potentially damage the camera and/or housing!

INSTALLING THE CAMERA

Since the FRX100 IV Housing is specifically designed for the Sony RX100 III & RX100 IV digital cameras,
installing the camera in the housing is quite simple.
1. Make sure the camera is turned off.
2. Hold the camera parallel to the housing and then gently install it inside (image #12). Avoid
inserting one side of the camera prior to the other, as this will make the installation difficult and
might cause damage to the camera or housing.
3. Take special care not to touch or damage the moisture detector device when installing the
camera. The Device is located inside the housing on the inner (right) side of the housing
interior to the latch dial (image #13 on the following page).
FRX100 IV Housing Instruction Manual 20150809
18
Image #12