Table of Contents
Advertisement
INSTALLING THE CAMERA
Since the FRX100 VA R Housing is specifically design
digital cameras, installing the camera
1. Make sure the camera is turned off
Make sure the camera is turned off.
2. Hold the camera parallel to the housing and then gently install it inside (image #
Hold the camera parallel to the housing and then gently install it inside (image #
Hold the camera parallel to the housing and then gently install it inside (image #13). Avoid
inserting one side of the camera prior to the other, as this will make the installation difficult and
ng one side of the camera prior to the other, as this will make the installation difficult and
ng one side of the camera prior to the other, as this will make the installation difficult and
might cause damage to the camera or housing.
might cause damage to the camera or housing.
3. Take special care not to touch or damage the
ake special care not to touch or damage the Vacuum System signal board when installing the
camera. The board is located inside the housing
opposite the latch dial (image #
atch dial (image #14).
specifically designed for the Sony RX100 V, RX100 IV
the camera in the housing is quite simple.
cated inside the housing on the inner right side of the housing
right side of the housing,
SIGNAL BOARD
FRX100 VA R Housing Instruction Manual
19
V, RX100 IV and RX100 III
when installing the
Image #1
13
Image #1
14
Instruction Manual 20200225
Hide quick links:
Advertisement
Table of Contents
