Installing The Camera - Fantasea Line FG7X II S Instruction Manual

6. The white O-ring featured on the back side of the front door should be visually inspected prior to
each dive. If there is any debris present, gently wipe the area with a soft microfiber cloth in order to
cleanse it.
7. The white O-ring featured on the back side of the front door shouldn't be removed unless it's
damaged.

INSTALLING THE CAMERA

Since the FG7X II S Housing is specifically designed for the Canon G7 X Mark II digital camera, installing
the camera in the housing is quite simple.
1. Make sure the camera is turned off.
2. Hold the camera parallel to the housing and then gently install it inside (image #9). Avoid
inserting one side of the camera prior to the other, as this will make the installation difficult and
might cause damage to the camera or housing.
3. Take special care not to touch or damage the Vacuum System signal board when installing the
camera. The board is located inside the housing on the inner right side of the housing,
opposite the latch dial (image #10).
FG7X II S Housing Instruction Manual 20220601
17
Image #9