Closing The Housing - Fantasea Line FA6500 Instruction Manual

the housing port hole. In such cases, the lens should be installed on the camera after the camera
has been inserted into the housing. The lens port should be mounted on the housing only after
the lens has been installed. Follow the steps below:
a. Prepare the housing as described in the section "Preparing the Housing", only without
mounting the lens port.
b. Prepare the camera as described in the section "Preparing the Camera", only without
installing the lens on the camera.
c. Follow the instructions provided above in this section to install the camera (without the
lens) inside the housing.
d. Once the camera is installed, the lens can be mounted on the camera through the
housing lens port hole (image
#50). Align the white dot on the
lens with the one marked on the
camera, attach the lens to the
camera and turn it clockwise until
it clicks.
e. Mount the lens port on the
housing (see section "Installing
and Removing Lens Ports").
f. To remove the camera and lens
from the housing, follow the
instructions provided at the end
of the section "Removing the
Camera from the Housing".

CLOSING THE HOUSING

1. Turn the latch dial so that the small red tab located on the latch is pointed towards the front side
of the housing (image #51 on the following page).
2. Carefully close the back door of the housing, pushing it against the front door, while making sure
there is nothing sticking out of the housing or impairing the smooth closure of the back door.
Then firmly press the back door against the forward section of the housing.
3. Turn the secure dial clockwise till the lock dial clicks. The small red tab should then be pointed
towards the bottom of the housing (image #52 on the following page).
4. Gently try pulling the back door away from the front door. If the housing is properly closed, it should
be impossible to open the back door.
Image #50
FA6500 Housing Instruction Manual 20170315
34