Installing The Camera - Fantasea Line FG9X Instruction Manual

INSTALLING THE CAMERA

Since the FG9X Housing is specifically designed for the Canon G9 X digital camera, installing the camera in
the housing is quite simple.
1. Make sure the camera is turned off.
2. Lift the housing Mode Dial so it doesn't interfere with camera installation (figure #10).
3. Make sure that the Flash Push-Down Lever is raised and pulled all the way to the left.
4. Hold the camera parallel to the housing and then gently install it inside (figure #11). Avoid
inserting one side of the camera prior to the other, as this will make the installation difficult and
might cause damage to the camera or housing.
5. Take special care not to touch or damage the moisture detector device when installing the
camera. The Device is located inside the housing on the inner (right) side of the housing
interior to the latch (figure #12).
www.fantasea.com | www.canondive.com
Figure #11
MOISTURE DETECTOR
18
MODE DIAL
Figure #10
Figure #12
FG9X Housing Instruction Manual 20160409