Fantasea Line FA6500 Instruction Manual page 21

1. C2 button – This button has no function when accommodating the a6300 inside the housing. To
avoid confusion, peel off the C2 label from this control or instead, attach the blank label sticker
included in the conversion kit (image #15).
2. C3 button – Peel off the C3 label from this control and instead, attach the C2 label sticker included in
the conversion kit (image #16).
Image #15
3. Shutter Release –
a. Open the housing and identify the interior component of the shutter release – a lever with a
black rubber tip featured at its end (image #17).
b. Remove the black rubber tip by gently pulling it out and store it for possible future use
(image #18).
Image #17
4. On/Off –
a. Open the housing and identify the interior component of the On/Off control – a black half-
cup-shaped plastic component secured to the control shaft with an e-clip (image #19 on the
following page).
b. Using a screwdriver or a similar tool, gently remove the e-clip featured at the bottom of the
black component (image #20 on the following page). Make sure you're removing the e-clip
that is positioned beneath the black component rather than above it, as removing the e-clip
above the black component will damage the watertight seal of the control. Also, make sure
not to cause any damage to the housing when using sharp tools.
Image #16
REMOVE TIP
21
Image #18
FA6500 Housing Instruction Manual 20170315