Fantasea Line FA6500 Instruction Manual page 24

depressing the control from out of the housing.
h. Test the control by gently trying to pull it out in order to make sure it has been properly
installed.
6. Front Stopper –
a. Identify the front stopper included in the conversion kit (image
#27). This stopper should be attached to a dedicated indentation
inside the front door of the housing (image #28).
b. Peel off the paper from the back of the stopper to expose the glue
applied on its sticker side.
c. Attach the stopper inside the front door of the housing by pushing
it into the round groove found right underneath the On/Off lever,
with the sticker side of the stopper facing the groove (image #29). Make sure the stopper is
attached within an accurate position to ensure perfect operation of all controls underwater.
INSTALL STOPPER
HERE
Image #28
Important
Note
Although the conversion process described above should not have any
effect on the watertight seal of the housing, it is important that the first
dive upon completing the conversion is carried out with the housing
empty (no camera installed inside) in order to verify that the housing
watertight seal has not been accidently affected.
Image #29
FA6500 Housing Instruction Manual 20170315
24
Image #27