Replacing The Alarm Unit - Fantasea Line FA6500 Instruction Manual

7. Gently push the new battery it into the battery compartment and make sure it doesn't fall off
easily.
WARNING
Install only 3V Lithium #CR1220 batteries inside the Moisture Alarm unit. Using any other type
of batteries will cause irreparable damage to the electrical unit.
8. To secure the battery and make sure it doesn't fall out of place, wrap the battery compartment
area with a small piece of electrical tape. Be careful not to cover the round cylinder which
produces the alarm sound. Alternatively, you can wrap the whole alarm unit with tape and then
make a hole over the alarm cylinder (image #65).
9. Insert the electrical wires plug back into the alarm unit socket.
10. Slide the alarm unit back into the dedicated slot inside the housing, opposite the buckle. Make
sure to install the unit with the round alarm cylinder facing the housing interior and the LED
pointing outwards, to the back of the housing (image #66).
11. You can test the Moisture Detector by placing a wet finger over the moisture sensor unit at the
bottom of the housing. Once you have confirmed that the alarm is working, gently dry off the
moisture sensor unit. This should silence the alarm.

REPLACING THE ALARM UNIT

1. Remove the alarm unit from the housing by gently sliding it out of its slot (image #61 on the
previous page).
2. Expose the white electrical plug under the black tape wrap (image #62 on the previous page).
3. Disconnect the electrical wires plug from the alarm unit socket.
4. Connect the electrical wires plug to the socket of a new alarm unit.
Image #65
45
Image #66
FA6500 Housing Instruction Manual 20170315