Installing The Camera - Fantasea Line FG7X II A M16 Instruction Manual

b. Slip the tip of the inserted O-ring remover below the black O-ring, while making sure the O-ring
doesn't get damaged (image #8).
c. Carefully hold the O-ring with your fingertips in order to remove it from the groove.
3. Cleaning the O-ring is a simple matter of wiping it with a damp, soft cloth to remove the foreign
matter. Be careful the cloth you use does not leave any of its own material behind as this can also
affect the effectiveness of the seal.
4. Apply a slight layer of silicone grease on the black O-ring. Please note that the amount of lubrication
required on the O-ring is only enough to allow it to slip into place without friction, so it does not
twist or become dislodged. More grease is not necessarily better, and in some cases might interfere
with the watertight seal of the housing.
5. When replacing the O-ring, place it back into the groove starting at one corner and gently pressing it
into the groove all around the housing until it is all seated in the groove and no part of it is sticking
up or out of the groove.
6. The white O-ring featured on the back side of the front door should be visually inspected prior to
each dive. If there is any debris present, gently wipe the area with a soft microfiber cloth in order to
cleanse it.
7. The white O-ring featured on the back side of the front door shouldn't be removed unless it's
damaged.

INSTALLING THE CAMERA

Since the FG7X II A M16 Housing is specifically designed for the Canon G7 X Mark II digital camera,
installing the camera in the housing is quite simple.
1. Make sure the camera is turned off.
Image #7
FG7X II A M16 Housing Instruction Manual 20191218
15
Image #8