Fantasea Line FA6500 Instruction Manual page 14

34. Moisture Detector Alarm Unit – The moisture detector preinstalled in the housing alerts of a
possible leak whenever moisture is detected by the sensor. The alarm unit of the Moisture Detector
is installed inside the housing, opposite the latch dial. For further information and instructions, please
refer to the section "Fantasea Moisture Detector".
35. Camera Tray – The tray allows for easy installation of the camera inside the housing and ensures the
camera is positioned securely and steadily during the dive.
Note that the camera battery compartment can be opened when the camera is installed on the tray,
allowing for easy and quick battery and memory card replacement without having to remove the
camera from the tray
For further instructions, please refer to the section "Installing the Camera".
36. Moisture Sensor Unit – The Moisture Sensor unit is installed just under the camera tray. It is
connected with a thin wire to the moisture detector alarm unit. For further information and
instructions, please refer to the section "Fantasea Moisture Detector".
37. Camera Tray Port – Secures the camera tray and ensures the camera is positioned firmly and tightly
inside the housing, allowing for smooth operation in all depths.
For further instructions, please refer to the section "Installing the Camera".
38. Lens Port Lock (Internal View) – After a lens port has been installed and the lens port lock has been
locked, it is recommended to examine the lock inside the housing to confirm that the port has been
properly installed and the port lock has been completely locked. For further instructions, please refer
to the section "Installing and Removing Lens Ports".
39. LED Trigger Ports – Designed to allow the use of an LED Flash Trigger inside the housing. The LED
Flash Trigger is a useful accessory when making use of slave strobes connected to the housing with
fiber optic cables. It attaches to the camera hot-shoe on one end and to the two LED Trigger Ports on
the other end. When an image is captured, the device LEDs installed inside the LED Trigger Ports
trigger the slave strobe without activating the camera built-in flash. This spares camera battery
consumption and also prevents the built-in flash recycle time from limiting continuous shooting. For
LED Trigger Ports available, please visit the Fantasea website – www.fantasea.com
FA6500 Housing Instruction Manual 20170315
14