Installing The Camera - Fantasea Line FA6000 Instruction Manual

5. When replacing the O-ring, place it back into the groove starting at one corner and gently
pressing it into the groove all around the housing until it is all seated in the groove and no
part of it is sticking up or out of the groove.
6. The white O-ring featured on the back side of the front door should be visually inspected
prior to each dive. If there is any debris present, gently wipe the area with a soft microfiber
cloth in order to cleanse it.
7. The white O-ring featured on the back side of the front door shouldn't be removed unless
it's damaged.

INSTALLING THE CAMERA

Since the FA6000 Housing is specifically designed for the Sony a6000 digital camera, installing the camera in
the housing is quite simple.
1. If possible, it is recommended to install the camera inside the housing after the lens port has
been mounted on the housing. If using exceptionally large lenses which cannot be installed on
the camera prior to inserting it into the housing since the lens is too large be inserted through
the housing lens port hole, the lens port should be mounted on the housing only after the
camera and lens have been inserted. In such cases, please follow the instructions provided in
step 18 below for camera installation.
2. Place the housing on a protected surface.
3. Open the housing (see section "Opening the Housing").
4. Prepare the camera following the instructions provided in the section "Preparing the Camera".
5. Turn the camera tray port lock rightwards, to the "UNLOCK" position (image #23).
6. Remove the camera tray from its port by
gently sliding it out.
7. Prior to mounting the camera on the
tray, the camera LCD screen should be
tilted in order to allow proper
attachment to the tray. Pull out the
bottom of the LCD screen all the way
out (image #24 on the following page).
After camera installation, the LCD
screen should be realigned for a clear
view.
Image #23
FA6000 Housing Instruction Manual 20190204
25