Fantasea Line FA6500 Instruction Manual page 20

1. C1 button –
a. Open the housing (see section "Opening the Housing") and identify the interior component
of the C1 button – a black lever secured to the control shaft with an e-clip (small metal clip)
(image #11).
b. Using a screwdriver or a similar tool, gently remove the e-clip featured at the bottom of the
black lever (image #12). Make sure you're removing the e-clip that is positioned beneath the
lever rather than above it, as removing the e-clip above the lever will damage the watertight
seal of the control. Also, make sure not to cause any damage to the housing when using
sharp tools.
Image #11
c. Gently remove the lever by pulling it down, out and away from the control shaft using your
fingers. You might find it easier to do so when depressing the control from out of the
housing.
d. Store the e-clip and lever removed for possible future use.
e. Identify the thin black plastic tube included in the conversion kit (image #13).
f. Install the black plastic tube on the control by pushing it upwards against the exposed metal
shaft of the control, so that the metal shaft is fully inserted inside the black plastic tube
(image #14).
Image #13
Image #12
Image #14
20
FA6500 Housing Instruction Manual 20170315