Table of Contents
Advertisement
SETTING UP THE HOUSING
Important
Notes
PREPARING THE CAMERA
1. Install a (preferably empty) memory card (32 GB+ capacity recommended) and a fully charged
battery inside the camera.
2. Remove the camera strap from the camera if one was installed.
3. Note that there is no need to remove the eyepiece rubber cup, as it doesn't interfere with
installation or operation of camera inside the housing.
4. Install the selected lens on the camera and remove the lens cap from lens.
5. If making use of a lens gear and/or light shading pad, install them on the lens following the
instructions provided with these accessories.
6. Built-in Flash Push Down Reminder Sticker –
Prior to installing the camera inside the
housing, the camera built-in flash must be
pushed into the camera body. Any attempt of
installing the camera into the housing with
the flash popped-up might damage the
camera and the housing and will necessarily
interfere with a proper watertight seal of the
housing. A dedicated warning sticker was
designed for the purpose of reminding you to push the built-in flash into the camera body prior
to installing it into the housing. It is recommended to attach this sticker on the camera, at the
back of the popped–up built-in flash (image #1).
It is important that a first dive is always carried out with the housing
empty (no camera installed inside) in order to verify that the housing
watertight seal has not been affected during lens port installation, M16
port accessories installation, transport or long periods of storage.
When using the housing to accommodate the a6300 camera, a few simple
steps should first be followed in order to convert the housing to fit this
camera. Please follow the instructions provided in page 19 prior to
installing the camera inside the housing. Alternatively, this conversion can
be carried out by an authorized Fantasea dealer or a Fantasea service
center.
Attach the
sticker here
Image #1
FA6500 Housing Instruction Manual 20170315
16
Advertisement
Table of Contents
