Fantasea Line FA6500 Instruction Manual page 18

4. Installing the Extended Shutter Trigger – When mounting the housing on a tray & handle or tray
& arm system, you might consider replacing the shutter release trigger with the extended
replacement trigger included in the package. The extended trigger provides easier access to the
shutter release when an arm or handle are mounted next to the housing. To replace the shutter
release trigger with the extended one included, complete the following steps:
a. Place the housing on a protected surface.
b. Identify the Extended Shutter Release Kit (image #5).
c. Using the screwdriver included in the kit, remove the screw that secures the shutter
release trigger (image #6). Store it safely, although a spare screw is included in the kit.
Image #5
d. Remove the trigger by pulling it out and away from the housing (image #7). Note that
once the trigger has been removed, the control metal shaft can be accidently pushed
in, resulting with the spring in the interior of the control slightly moving out of place
and thus disabling proper operation of the control. Therefore, make sure not to push
the control shaft into the housing. Store the removed trigger for possible future use.
e. Install the replacement extended trigger on the exposed metal shaft of the control by
aligning the protrusion featured on the control with the shape of the shaft (image #8).
Image #7
Image #6
Image #8
FA6500 Housing Instruction Manual 20170315
18