Grounding A Cable - Mitsubishi Electric GOT2000 Series User Manual

5.2.6

Grounding a cable

■1. Grounding method
Ground the cable and ground cable to the control panel where the GOT and the PLC are installed.
Ground the braided shield section of the cable to the control panel with the cable clamp (AD75CK).
Ground the ground cable to the FG terminal
at the GOT power supply section when using
GT15-C□EXSS-1 or GT15-C□BS.
To ground a bus connection cable, ground the braided cable for grounding to the control panel by tightening a screw.
■2. Precautions
Do not arrange the cable clamp close to the other cables that are not clamped.
The noise from the control panel may enter the cable clamp and adversely affect the GOT.
5 - 18
5.2 EMC Directive Requirements
Cable clamps
For the attachment details of cable clamps, refer to
AD75CK-type Cable Clamping Instruction Manual
<IB-68682>.
GOT FG terminal FG wire
Braided shield
Bus connection cable