Removing The Sd Card - Mitsubishi Electric GOT2000 Series User Manual

6.12 Removing the SD Card

If the SD card mounted on drive A of the GOT is removed while the GOT is accessed, processing for
the GOT might be interrupted about for 20 seconds.
The GOT cannot be operated during this period.
The functions that run in the background including a screen updating, alarm, logging, scripts, and
others are also interrupted.
This stop affects the system operation, causing an accident.
Remove the SD card after checking the following items.
• GT27, GT25, GT23
Check that the SD card access LED is off before removing the SD card.
• GT21
Disable the SD card access in the GOT utility, and then check that the SD card access LED is off
before removing the SD card.
If the data storage mounted on the GOT is removed while the GOT is accessed, the data storage and
files are damaged.
To remove the data storage from the GOT, check that the access to the data storage in SD card
access LED, the system signal, and others is not performed.
When using the GOT with an SD card inserted, check the following items.
• GT27, GT25, GT23
When inserting a SD card into the GOT, make sure to close the SD card cover.
Failure to do so causes the data not to be read or written.
• GT21
When inserting an SD card into the SD card unit, make sure to enable the SD card access in the
GOT utility in advance.
When removing the SD card from the GOT, make sure to support the SD card by hand as it may pop
out.
Failure to do so may cause the SD card to drop from the GOT, resulting in a failure or break.
Before removing the USB device from the GOT, follow the procedure for removal on the utility screen
of the GOT.
After the successful completion dialog is displayed, remove the USB device by hand carefully.
Failure to do so may cause the USB device to drop from the GOT, resulting in a failure or break.
The following shows the procedure for removing an SD card.(Described with the GOT rear face facing up.)
WARNING
CAUTION

6.12 Removing the SD Card

6
6 - 55