Mitsubishi Electric GOT2000 Series User Manual page 146

The following table lists the distance required between the GOT and the other devices.
The dimensions within the parentheses apply when no equipment generating radiated noise (such as a contactor) or heat is
installed near the GOT.
Item
*2
A
B
When the SD card is used
C
When the SD card is not
used
D
*1
E
*1
*2
6 - 18
6.4 Installation Position
For GT2104-RTBD, GT2104-PMBDS, GT2104-PMBDS2, GT2103-PMBDS, and GT2103-PMBDS2, a distance of 80 mm (3.15
inches) or more is required to connect an RS-232 cable or personal computer connection cable to the GOT rear face.
When a user-created RS-232 cable is connected to the connector terminal block at the rear face of GT2104-RTBD, a distance of
20 mm (0.79 inch) or more is required.
For GT2107, a distance of 60 mm (2.36 inches) or more is required to connect an RS-485 cable or RS-232 cable.
GT21
GT2107, GT2105, GT2104-R, GT2104-P, GT2103-P
50 (1.97) or more [20 (0.79) or more]
50 (1.97) or more [20 (0.79) or more]
50 (1.97) or more
50 (1.97) or more [20 (0.79) or more]
50 (1.97) or more
80 (3.15) or more [20 (0.79) or more]
Unit: mm (inch)