6.4
Installation Position
To install the GOT, some distance is required between the GOT and the other devices.
6.4.1
GT27
Depending on the units and cables used for the GOT, the distance more than the described dimensions may be required.
Install the GOT with consideration of the connector dimensions and the cable bend radius.
For the cable pull-out distance from the bottom of the GOT, refer to the following.
➠
For the vertical installation, install the GOT so that the vertical installation arrow printed on the GOT rear face points upward.
➠
6 - 10
6.4 Installation Position
11.2 Depth Dimensions and Cable Bend Radius for GT27 with an Extension Unit
4.1 GT27
B
C
A
Horizontal
D
C
Vertical
D
Panel thickness: 1.6 mm to 4 mm
A
Panel thickness: 1.6 mm to 4 mm
E
(0.06 to 0.16inch)
E
(0.06 to 0.16inch)